1.
Do I need to use all of the miscellaneous hardware that comes with the brakes?
No - back to top
2. Are there any written directions that come with the HYD brake package or is it just the picture?
Your assembly instructions will be included as separate written information and will be found tucked inside the left hand part of your construction manual.
Click here for instructions.
(page will open in new window)
- back to top
3. With the toe brake set-up, where do I mount the lever type dual set up?
With a toe brake set-up there is no dual lever type set up. -
back to top
4. Do I need to disassemble the hydraulic brake axle assembly that came with my kit before installing it? Yes. Refer to the instructions and the pictures that were sent with your kit. Step # 1 needs to be done before you can drill the axle!
- back to top
5. What is the correct process for installing the stub axle?
The silver sleeve has to be flush with the outside of the axle (2-55). You can silicone it into place so that it does not move when you slide the stub axle in to the 2-55. Slide the stub axle in until it is tight to the hub. Drill the sleeve and the stub axle by using the hole in the 2-55 as a guide. Drill only half way through the axle from one side and then drill the rest from the other side.
- back to top
6. Where does the metal arm go that is slightly bent?.
The metal arm faces down and aft - back to top
7. The tail wheel cables have no slack on either side with the wheel straight and the springs are under no tension. Will this cause me to go off center?
No. - back to top
We hope that we have clarified a few of your
questions. If you do require additional assistance, we would be very happy to hear from
you with your questions, comments or concerns.
|
 |
 |
|
ATTENTION:
We answer all our e-mails promptly within 24 - 48 hours and if
you have not heard from us, it is possible that your e-mail
has landed in our SPAM mail. Please, if you have not heard
from us within that time frame, send the e-mail again or call
us at 250-549-1102. |
